toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Power Steering Pump|Removal and Installation|Page 6932 > < Power Steering Pump|Removal and Installation|Page 6930
Page 4
background image

Part Number: 44345-26020
Plate Length: 14.997-14.999 mm (0.59043-0.59051 inch).

Mark: 2
Part Number: 44345-26030
Plate Length: 14.995-14.997 mm (0.59035-0.59043 inch).

Mark: 3
Part Number: 44345-26040
Plate Length: 14.993-14.995 mm (0.59027-0.59035 inch).

Mark: 4
Part Number: 44345-26050
Plate Length: 14.991-14.993 mm (0.59020-0.59027 inch).

3. Inspect the flow control valve by doing the following

a. Coat the valve with power steering fluid and check that it falls smoothly into the valve hole by its own weight.

b. Check the flow control valve for leakage.Close one of the holes and apply compressed air 392-490 kPa (57-71 psi) into the opposite side, and

confirm that air does not come out from the end hole.

c. If necessary, replace the valve with one having the same letter as inscribed on the front housing. The inscribed marks are A, B, C, D, E or F.

Power Steering Pump|Removal and Installation|Page 6932 > < Power Steering Pump|Removal and Installation|Page 6930