4 Runner 2WD L4-2693cc 2.7L DOHC MFI (1997)
f.
Using a punch, stake the nut.
8. install the control valve housing with the control valve assembly, doing the following.
a. Coat a new O-ring with power steering fluid, and install it to the valve housing.
b. Align the matchmarks on the valve housing and rack housing, and install the valve housing with the valve assembly to the rack housing.
c. Tighten the two bolts to 18 Nm (13 ft. lbs.).
9. Install the dust cover.
10. Install the rack guide, rack guide spring and the rack guide spring cap by performing these procedures.
a. Apply Part No. 0883-00080, THREE BOND 1344, LOCTITE 242 or equivalent sealant to 2 or 3 threads of the cap.
b. Temporarily install the cap.
11. Adjust the total preload, doing the following.
a. To prevent the steering rack teeth from damaging the oil seal lip, temporarily install the right and left hand rack ends.
b. Tighten the rack guide spring cap to 25 Nm (18 ft. lbs.).
c. Return the cap 19°.
d. Using the 09616-00010 SST, turn the control valve shaft right and left one or two times.
e. Loosen the cap until the rack guide spring is not functioning.