4 Runner 2WD L4-2693cc 2.7L DOHC MFI (1997)
c. Using a brass bar and hammer, stake the washer.
NOTE: Avoid any impact to the rack.
14. Install the right and left rack boots, clamps and clips, performing the following.
a. Ensure that the tube hole is not clogged with grease.
NOTE: If the tube hole is clogged, the pressure inside the boot will change after it is assembled and the steering wheel is turned.
b. Install the boot.
NOTE: Be careful not to damage or twist the boot.
c. Tighten a new clamp, as shown in the illustration.
NOTE: Face the projection to upper side of the vehicle.
15. Install the right and left hand tie rod ends and lock nuts, doing the following.
a. Screw the lock nut and tie rod end onto the rack end until the matchmarks are aligned.
b. After adjusting toe-in, tighten the nut to 55 Nm (41 ft. lbs.).
