4 Runner 2WD L4-2693cc 2.7L DOHC MFI (1997)
Measure planetary pinion gear thrust clearance.
Using a feeler gauge, measure the planetary pinion gear thrust clearance.
Standard clearance: 0.20 - 0.60 mm (0.0079 - 0.0236 in.)
Maximum clearance: 1.00 mm (0.0394 in.)
If the clearance is greater than the maximum, replace the planetary gear assembly.
REAR PLANETARY GEAR, NO.2 ONE-WAY CLUTCH AND OUTPUT SHAFT ASSEMBLY
1. Install ring gear flange.
a. Install the ring gear flange.
b. Using a screwdriver, install the snap ring.
2. Install races and bearing.
Coat the races and bearing with petroleum jelly, and install them onto the rear planetary ring gear.
3. Install No.1 and No.2 thrust washers.
a. Coat the thrust washers with petroleum jelly.
b. Install the thrust washers onto both sides of the rear planetary gear.
HINT: Make sure that the lug shapes match the cutout portions on the rear planetary gear.
