4 Runner 2WD L4-2693cc 2.7L DOHC MFI (1997)
d. Position the backing plate on a new bearing case and, using two socket wrenches and a install the four serration bolts.
e. Install a new bearing and (outer side) oil seal.
9. Replace the (inner side) oil seal by doing these steps.
a. Using the 09308-0010 SST, remove the oil seal.
b. Using the 09950-60020 (09951-00710), 09950-70010 (09951 -07150) SST and a hammer, install a new oil seal.
c. Apply MP grease to the oil seal lip.
10. Install the rear axle shaft in the backing plate by performing the following.
a. Apply IMP grease to the oil seal lip.
b. Install the backing plate and bearing retainer on the rear axle shaft.
c. Using the 09316 60010 (0931-00050) SST and a press, install the rear axle shaft into the backing plate.
d. Using snap ring pliers, install a new snap ring.
11. If the vehicle came w/ ABS, using the 09316 60010 (0931-00050) SST and a press, install a new ABS speed sensor rotor and new (differential
side) bearing retainer to the axle shaft. The standard length is 122.2 + 1.0 mm (4.811-0.039 inch).
Hub Bolt
REPLACEMENT
1. Remove the wheel and the brake drum.
