4 Runner 2WD V6-4.0L (1GR-FE) (2006)
4. Set the hand-held tester in test mode ("TEST MODE").
HINT: Refer to the hand-held tester operator for further details
5. Keep the vehicle in a stationary condition on a level surface for 2 seconds or more.
6. Check that the VSC TRAC warning light is blinking in test mode.
NOTE: The VSC TRAC warning light stays on when obtaining the zero point.
HINT:
-
If the VSC TRAC warning light does not blink, perform the zero point calibration again.
-
The zero point calibration is performed only once after the system enters test mode.
-
Calibration cannot be performed again until the stored data is cleared once.