4 Runner 2WD V6-4.0L (1GR-FE) (2006)
/Page-1434001.png)
Seat Belt Reminder Lamp: Testing and Inspection
INSPECT SEAT BELT WARNING LIGHT (DRIVER SIDE)
a. Check the operation.
1. Turn the ignition switch to ON, and check that the warning light blinks.
2. Fasten the outer belt to the inner belt and check that the warning light goes off.
3. Disconnect the connector from the front seat inner belt assembly (driver side), and connect the terminal on the wire harness side connector to
body ground.
4. Turn the ignition switch to ON, and check that the warning light blinks.
