4 Runner 2WD V6-4.0L (1GR-FE) (2006)
A. Place the seat assembly in the cabin.
NOTE
Be careful NOT to damage the body.
B. Connect the connectors under the seat assembly.
C. Tighten the 2 bolts on the front side of the seat assembly.
Torque: 37 N*m (375 kgf*cm, 27 ft*lbf)
D. Tighten the 2 bolts on the rear side of the seat assembly.
Torque: 37 N*m (375 kgf*cm, 27 ft*lbf)
E. Install the seat track covers.
11. Check SRS warning light.
12. Check seat slide adjuster locks.
13. Initialize the front passenger Occupant Classification System (OCS) (passenger seat only).
NOTE
For the initialization procedure, refer to the TIS, applicable model and model year Repair Manual (reference the proper symptom experienced on
the test drive):
^
2006/2007/2008 4Runner Repair Manual Vehicle Interior - Supplemental Restraint System - "Supplemental Restraint System: Occupant
Classification System: Initialization"
14. Initialize power systems (windows moonroof etc.). Refer to appropriate service bulletin.
15. Refer to the Airbag Disposal section to dispose of the side airbag assembly.