4 Runner 2WD V6-4.0L (1GR-FE) (2006)
c. Remove the O-ring.
d. Carefully mount the control valve assembly in a soft jaw vise.
e. Using SST, remove the bearing guide nut.
SST 09631-20060
NOTICE: Be careful not to damage the oil seal lip.
f.
Remove the O-ring.
g. Remove the dust cover.
h. Using SST and a hammer, drive out the oil seal from the bearing guide nut.
SST 09950-60010 (09951-00300), 09950-70010 (09951-07100)
i.
Wind vinyl tape to the control valve shaft.
j.
Using a plastic hammer, tap out the valve assembly with the bearing guide nut from the control valve housing.
NOTICE: Be careful not to damage the oil seal lip.
k. Using a screwdriver, remove the 4 teflon rings from the control valve assembly.
NOTICE: Be careful not to damage the grooves for the ring.
l.
Using a screw extractor, remove the union seat from the control valve housing.