4 Runner 2WD V6-4.0L (1GR-FE) (2006)
a. Install the coil spring on the body as the lower end of the coil spring faces rear side of the vehicle.
b. Install the 3 nuts on the upper side of the front shock absorber with coil spring.
Torque: 64 Nm (650 kgf-cm, 47 ft. lbs.)
c. Temporarily tighten the bolt, the nut and the washer as shown in the illustration.
d. Install the bolt.
Torque: 29 Nm (300 kgf-cm, 21 ft. lbs.)
NOTICE: Be sure to fit the detents attached to the bracket into a hole on the frame side.