4 Runner 2WD V6-4.0L (1GR-FE) (2006)
3.
On the front of the sensor there is a 7-digit ID number as shown in the figure below. Write this number down for future reference (it will be input
using the Diagnostic Tester).
4.
Reseat the tire back to the wheel and set the tire pressure of all wheels to the specified value.
5.
Remount the tire and wheel assembly to the vehicle.
6.
Torque all wheels to the vehicle according to vehicle recommendations.
7.
Go to the Tire Pressure ID Registration Procedure".
Tire Pressure ID Registration Procedure
1.
Connect the Diagnostic Tester to DLC3.
2.
Turn the ignition switch to the ON position.