4 Runner 2WD V6-4.0L (1GR-FE) (2006)
NOTE:
- Dry the primer coating for 3 minutes or more.
- Check that the clips are attached to the body correctly.
- Check the clearance between the body and glass.
2. Lightly press the glass front surface for close contact.
3. Using a scraper, remove any excess or protruding adhesive.
HINT: Apply adhesive onto the glass rim.
NOTE: Take care not to drive the vehicle curing the time described in the table below.
Minimum time:
8. INSPECT FOR LEAKS AND REPAIR
a. Conduct a leak test after the adhesive has completely hardened.
b. Seal any leaks with auto glass sealer.