4 Runner 4WD V8-4.7L (2UZ-FE) (2003)
A.
Place a flathead screwdriver against the stepped portion of the holder and lightly tap the screwdriver using a hammer to release the holder.
B.
Move the holder toward the front of the vehicle by pushing it with the screwdriver and remove it from the rail.
5.
Replace the grease.
A.
Using a piece of cloth or scraper remove the old grease from the holder-sliding surface on the rail and the deflector arm.
NOTE
Remove the grease on both the RH and LH sides.
B.
Install the NEW holder (P/N 63257-35040/50 included in repair kit P/N 63207-35040) to the rail by performing the removal procedure in
reverse order.
C.
Push the rod into the holder.