4 Runner 4WD V8-4.7L (2UZ-FE) (2003)
A.
While pressing the board to the vehicle front side (push in on the seatback board), pull the seatback board toward the seat center in order to
disconnect the two claws (A) on each of the side surfaces of the board.
B.
While pressing the board toward the vehicle front side, pull it downward and disconnect the two claws (B) at the top of the board.
8.
Attach felt between the seatback pad and the projecting wires.
Felt size:
Length: 40 mm
Width: 40 mm
Thickness: 2 mm
NOTE:
While pressing the seatback pad to the vehicle front side by hand and securing a space between the seatback pad and the projecting wires,
securely attach a piece of felt on each side of the pad as shown in the illustration.