4 Runner 4WD V8-4.7L (2UZ-FE) (2003)
8.
For seats equipped with side airbag:
Remove the seat back cover bracket set nut (bracket found only on the outside seat back frame rail).
9.
For seats equipped with side airbag:
Remove the two seat back cover brackets from the frame.
10.
While moving the seat back pad to gain access to the seat frame, attach a piece of felt to the wire.
Felt Size:
Length: 185 mm
Width: 40 mm
Thickness: 2 mm
NOTE:
^
Be careful not to open the pad too much as the seat back pad could tear.
^
Securely align the felt as shown in the illustration so that it cannot come off.
^
Be sure to align the overlapping felt so it faces towards the rear of the vehicle as shown.
11.
Repeat step 10 for the opposite side.