4 Runner 4WD V8-4.7L (2UZ-FE) (2003)
16.
Pull the flap of the seat back cover up and affix it to the frame with hog rings using hog ring pliers.
NOTE:
^
Be sure to use coated hog rings (90468-16019) to prevent any abnormal noise.
^
Non-reusable part.
17.
Pull out the seat back cover end at both ends of the seat back cover so that the seat back cover end does not sag and affix it to the frame with hog
rings using hog ring pliers.
18.
Remove the four seat track mounting bolts.
19.
Zip the seat fastener, and push the end of the seat fastener between seat cover end and seat frame.
20.
Lift up the seat back side of the seat.
21.
Connect the two seat backboard cover rubber bands to the hooks.
22.
Install the four seat track mounting bolts.
Torque: 37 N-m (375 kgf-cm, 27 ft-lbf)
23.
Install the four seat track covers.
24.
Install the headrest assembly.