4 Runner 4WD V8-4.7L (2UZ-FE) (2003)
b. Fix the brake control wire to the brake booster pump bracket No.2 with the new clamp.
43. INSTALL BRAKE ACTUATOR HOSE
a. Using needle nose pliers, install the brake actuator hose and 2 clips.
44. INSTALL BRAKE ACTUATOR TUBE NO. 1
a. Using SST, install the brake actuator tube No.1 to the brake master cylinder and brake booster pump assy.
SST 09023-00100
Torque: 15.2 Nm (155 kgf-cm, 11 ft. lbs.)
45. INSTALL BRAKE ACTUATOR BRACKET NO.4
a. Install the brake actuator bracket No.4 to the brake master cylinder with the bolt.
Torque: 7.8 Nm (80 kgf-cm, 69 inch lbs.)
46. INSTALL BRAKE ACTUATOR BRACKET NO. 1
a. Using a hexagon wrench (5 mm), install the brake actuator bracket No.1 the brake master cylinder with a bolt.
Torque: 7.8 Nm (80 kgf-cm, 69 inch lbs.)
47. INSTALL BRAKE MASTER CYLINDER KIT
a. Apply the lithium soap base glycol grease to the master cylinder piston, brake booster piston and brake booster plug.
b. Install the master cylinder piston, brake booster piston and brake booster plug.
c. Pressing brake booster plug, install a new snap ring.
48. INSTALL MASTER CYLINDER RESERVOIR GROMMET
a. Apply the lithium soap base glycol grease to new 3 reservoir grommets.