4 Runner 4WD V8-4.7L (2UZ-FE) (2003)
20. REMOVE BRAKE CONTROL WIRE
a. Remove the 4 screws.
b. Disconnect the clamp and remove the brake control wire.
21. REMOVE OIL PRESSURE SENSOR
a. Remove the oil pressure sensor from brake master cylinder.
b. Remove the spacer and O-ring from the oil pressure sensor.
22. REMOVE BRAKE BOOSTER PUMP BRACKET NO.3
a. Using a hexagon wrench (5 mm), remove the 2 bolts and brake booster pump bracket No.3.
23. REMOVE BRAKE BOOSTER PUMP BRACKET NO.2
a. Hold the w/accumulator pump assy, then using a hexagon wrench (5 mm), and remove the bolt and brake booster pump bracket No.2 from
brake master cylinder.
24. REMOVE BRAKE BOOSTER W/ACCUMULATOR PUMP ASSY
a. Remove the brake booster w/accumulator pump assy from brake master cylinder.
25. REMOVE BRAKE BOOSTER PUMP BRACKET NO.1
a. Remove the bolt and brake booster bracket No.1 from brake booster w/accumulator pump assy.
b. Remove the 2 washers, 3 bushes, 2 collars and shaft from brake booster w/accumulator pump assy.