4 Runner 4WD V8-4.7L (2UZ-FE) (2003)
/Page-398005.png)
18. REMOVE CRANKSHAFT DAMPER SUB-ASSY
a. Using SST, remove the pulley bolt.
SST 09213-70011 (09213-70020), 09330-00021
b. Using SST, remove the crankshaft pulley.
SST 09950-50013 (09951-05010, 09952-05010, 09953-05010, 09953-05020, 09954-05021),
19. REMOVE TIMING BELT No.1 COVER
a. Remove the 4 bolts and timing belt cover.
20. REMOVE CRANKSHAFT POSITION SENSOR PLATE No.1
21. REMOVE TIMING BELT
a. If re-using the timing belt, check the installation marks on the timing belt.
1. Check that there are 3 installation marks on the timing belt by turning the crankshaft as shown in the illustration.
If the installation marks have disappeared, place a new installation mark on the timing belt before removing each part.
b. Set the No.1 cylinder to approximately 50° BTDC/compression.
1. Using the crankshaft damper bolt, turn the crankshaft to align the timing marks of the crankshaft timing pulley and oil pump body.
