4 Runner 4WD V8-4.7L (2UZ-FE) (2003)
7. REMOVE SIDE TRIM BOX ASSY RH
8. REMOVE DECK TRIM SIDE PANEL ASSY RH
9. REMOVE ROOF SIDE GARNISH ASSY INNER RH
10. REMOVE REAR DOOR SCUFF PLATE RH
11. REMOVE REAR DOOR SCUFF PLATE LH
12. REMOVE REAR DOOR WEATHERSTRIP RH
13. REMOVE DECK BOARD ASSY
14. REMOVE BACK DOOR WEATHERSTRIP
15. REMOVE DECK TRIM COVER REAR
16. REMOVE REAR SEAT CUSHION ASSY AND REAR SEAT BACK ASSY
17. REMOVE DECK TRIM SIDE PANEL ASSY RH
18. REMOVE REAR SEAT 3 POINT TYPE BELT ASSY OUTER
a. Remove the bolt and disconnect the belt assy on the shoulder anchor side.
19. REMOVE REAR SEAT BELT ASSY OUTER CENTER
a. Remove the rear seatback board RH .
b. Remove the rear seat shoulder belt cover.
c. Remove the bolt and nut rear seat belt assy outer center.
20. REMOVE REAR SEAT INNER W/CENTER BELT ASSY LH
a. Remove the bolt and the belt assy.
21. INSTALL REAR SEAT BELT ASSY OUTER CENTER
a. Install the belt assy with the bolt and nut.
Torque: 42 N.m (430 kgf.cm, 31 ft.lbf)
b. Install the rear seat shoulder belt cover.
c. Install the rear seatback board RH.
d. Check the degree of tilt when the belt begins to lock the ELR.
1. Check the belt does not lock within 15° of tilt in all the direction but the belt locks over 45° of tilt, when moving the installed retractor
gently.
If operation is not as specified, replace the belt assy.
e. Install the assy with the bolt.
Torque: 42 N.m (430 kgf.cm, 31 ft.lbf)
f.
Check the ELR lock.
NOTE: The check should be performed with the assembly Installed.