4 Runner 4WD V8-4.7L (2UZ-FE) (2003)
/Page-1291002.png)
12. REMOVE AIR BAG SENSOR REAR LH
a. Disconnect the connector of the airbag sensor rear LH.
b. Remove the 2 nuts and the airbag sensor rear LH.
13. INSTALL AIR BAG SENSOR REAR LH
a. Install the airbag sensor rear LH with the 2 nuts.
Torque: 17.5 N.m (178 kgf.cm, 13 ft.lbf)
b. Connect the connector of the airbag sensor rear LH.
NOTE:
-
Installation of the connector is done with the sensor assembly installed. Make sure the sensor assembly is installed with the specified
torque.
-
If the sensor assembly has been dropped, or there are cracks, dents or other defects in the case, bracket or connector, replace the sensor
assembly with a new one.
-
When installing the sensor assembly, take care that the SRS wiring does not interfere with other parts and is not pinched between other
parts.
-
After installation, shake the sensor assembly to check that there is no looseness.
14. INSPECT AIR BAG SENSOR REAR LH
15. INSPECT SRS WARNING LIGHT
