4 Runner 4WD V8-4.7L (2UZ-FE) (2003)
B.
Strip off the vinyl tape from the branch wire harness of the connector.
C.
Cut the green wire (connector C10, pin 9) approximately 50 mm (1.97 in.) from the connector.
D.
Strip off the vinyl tape from the blue rheostat wire harness connector R13 up to the clamp.
NOTE:
For further vehicle wiring illustration, please see 2003 4Runner Electrical Wiring Diagram (EWD) page 162, connector C10, pin 9 and R13,
pin 1.
E.
Cut the yellow-red wire approximately 50 mm (1.97 in.) from the connector (connector R13, pin 1).