4 Runner 4WD V8-4.7L (2UZ-FE) (2003)
/Page-1077009.png)
A.
Remove the cotter pin and nut.
B.
Using the SST, separate the tie rod end from the steering knuckle arm.
SST P/N: 09628-62011
16.
Remove the steering sliding yoke.
A.
Mark matchmarks on the steering sliding yoke, steering intermediate shaft sub-assembly No. 2, and steering intermediate shaft assembly.
B.
Remove bolt A and bolt B from the steering sliding yoke.
C.
Slide the steering sliding yoke up and separate it from the steering intermediate shaft sub-assembly No. 2.
D.
Pull down the steering sliding yoke from the steering intermediate shaft assembly to remove.
17.
Remove steering intermediate shaft No. 2.
A.
Mark the matchmarks on the power steering gear assembly and steering intermediate shaft sub-assembly No. 2.
B.
Remove bolt C and the intermediate shaft sub-assembly No. 2 from the power steering gear assembly.
18.
Disconnect the pressure feed tube assembly.
A.
Using the 17 mm Union nut wrench (or equivalent), loosen the flare nut and disconnect the pressure feed tube.
