4 Runner 4WD V8-4.7L (2UZ-FE) (2003)
Fluid - Transfer Case: Service and Repair
TRANSFER OIL ADJUSTMENT
1. INSPECT TRANSFER OIL
a. Remove the filler plug and gasket.
b. Check the oil level is within 0 - 5 mm (0 - 0.1968 inch) down from the lowest end of the hole for filler plug.
NOTICE:
-
When changing oil, recheck the oil level after driving.
-
Excessively large or small quantity of oil may cause some trouble.
c. When the oil level is too low, check for oil leakage.
d. Tighten the filler plug with a new gasket.
Torque: 37 Nm (377 kgf-cm, 27 ft. lbs.)
2. ADJUST TRANSFER OIL
a. Remove the filler plug and gasket, and supply oil.
When supplying oil, pour it slowly. Repeat supplying oil several times at several minutes interval.
HINT: Within 0 - 5 mm (0 - 0.1968 inch) down from the lowest end of the hole for the filler plug.
b. After leaving it alone for 5 min., check the oil level again.
c. Tighten the filler plug with a new gasket.
Torque: 37 Nm (377 kgf-cm, 27 ft. lbs.)