4 Runner 4WD V8-4.7L (2UZ-FE) (2003)
/Page-1752002.png)
1.
Remove the rear wiper arm head cap by releasing the four claws.
2.
Remove the retainer nut, then remove the rear wiper arm.
3.
Install new rear wiper arm.
A.
Clean the rear wiper pivot serration with a wire brush.
B.
Ensure the rear wiper motor is in the automatic stop position.
HINT:
To ensure that the rear wiper is in the automatic stop position:
a) Turn the rear wiper motor switch to the ON position.
b) Turn the wiper motor switch to the OFF position.
