4 Runner Limited 2WD V6-3.4L (5VZ-FE) (1997)
/Page-1773002.png)
4. Install new pads.
CAUTION: When replacing worn pads, the anti-squeal shims must be replaced together with the pads.
(a) Draw out a small amount of brake fluid from the reservoir.
(b) Press in the pistons with a monkey wrench handle or an equivalent.
NOTE:
-
Tape the monkey wrench handle before use.
-
Always change the pad on one wheel at a time as there is a possibility of the opposite piston flying out.
-
If the piston is difficult to push in, loosen the bleeder plug and push in the piston while letting some brake fluid escape.
(c) Install the anti-squeal shims to new pads.
NOTE: Apply disc brake grease to both sides of the inner anti-squeal shims, see EXPLODED VIEW of system.
(d) Install the 2 pads.
CAUTION: There should be no oil or grease adhering to the friction surfaces of the pads or the disc.
5. Install anti-rattle spring and 2 pins.
6. Install clip.
