4 Runner Limited 2WD V6-3.4L (5VZ-FE) (1997)
/Page-2043002.png)
2. DISCONNECT SUCTION TUBE AND LIQUID TUBE FROM COOLING UNIT FITTINGS
Torque:
Liquid tube: 14 N.m (140 kgf.cm, 10 ft.lbf)
Suction tube: 32 N.m (330 kgf.cm, 24 ft.lbf)
REMOVAL NOTE: Cap the open fittings immediately to keep moisture or dirt out of the system.
INSTALLATION HINT: Lubricate 2 new O-rings with compressor oil and install the tubes.
3. REMOVE 2 GROMMETS
4. REMOVE DRAIN PIPE GROMMET
5. REMOVE GLOVE COMPARTMENT PARTS
6. REMOVE No.4 HEATER TO REGISTER DUCT
7. REMOVE COOLING UNIT
a. Disconnect the connectors.
b. Remove the 3 screws bolt and the cooling unit.
INSTALLATION
Installation is in the reverse order of removal.
