4 Runner Limited 2WD V6-3.4L (5VZ-FE) (1997)
/Page-1929002.png)
a. Remove the four bolts and shift the brake dust cover towards the hub side (outside).
b. Using the 09710-30021 (09710-03051), 09950-40010 (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04030, 09957 -
04010, 09958-04010) Special Service Tool (SST), remove the axle hub from the steering knuckle.
c. Remove the bearing spacer and the ABS speed sensor rotor/ spacer.
3. Using a screwdriver, remove the oil seal (outside) from the steering knuckle.
4. Remove the bearing from the steering knuckle by doing the following.
a. Using snap ring pliers, remove the snap ring.
b. Using the 09950-60020 (09951-00810), 09950-70010 (09951-07150) SST and a press, remove the bearing from the steering knuckle.
ASSEMBLY
1. Install the new bearing, performing these procedures.
a. Using the 09527 - 17011, 09950-60020 (09951 - 00910) Special Service Tool (SST) and a press, install a new bearing to the steering knuckle.
b. Using snap ring pliers, install a new snap ring.
2. Install a new (outside) oil seal by doing these steps.
a. Using the 09223-15030, 09527-17011 SST and a plastic hammer, install a new (outside) oil seal .
