4 Runner Limited 2WD V6-3.4L (5VZ-FE) (1997)
4. Install the cam ring with the inscribed mark facing outward.
NOTE: Align the holes of the cam ring with the straight pins.
5. Install the vane pump rotor by performing the following.
a. Install the rotor with the inscribed mark facing outward.
b. Install a new snap ring to the vane pump shaft.
6. Install the ten plates with the round end facing outward.
7. Install a new gasket on the front housing.
NOTE: Be careful the direction of the gasket.
8. Install the side rear plate after aligning the two straight pins and holes of the plate.