4 Runner Limited 2WD V6-3.4L (5VZ-FE) (1997)
Power Window Motor Circuit Breaker / Driver's Door
Driver's Door:
1. Disconnect the connector from the master switch.
2. Connect the positive (+) lead from the battery to terminal 3 and the negative (-) lead to terminal 6 on the wire harness side connector and raise the
window to full closed position.
3. Continue to apply voltage, check that there is a circuit breaker operation noise within approximately 4 to 40 seconds.
Power Window Motor Circuit Breaker / Driver's Door
4. Reverse the polarity, check that the window begins to descend within approximately 60 seconds.
If operation is not as specified, replace the motor.
Power Window Motor Circuit Breaker / Front Passenger's Door
Front Passenger's Door:
1. Disconnect the connector from the power window switch.
2. Connect the positive (+) lead from the battery to terminal 4 and the negative (-) lead to terminal 1 on the wire harness side connector, and raise the
window to full closed position.
3. Continue to apply voltage, check that there is a circuit breaker operation noise within approximately 4 to 40 seconds.
Power Window Motor Circuit Breaker / Front Passenger's Door