Avalon V6-3.5L (2GR-FE) (2006)
/Page-437011.png)
d. Remove the lock pin of chain tensioner assembly No.1. Check that each timing mark is aligned with the crankshaft at the TDC/compression.
e. Remove the pulley set bolt.
36. INSTALL TIMING CHAIN COVER OIL SEAL
SST 09316-60011 (09316-00011)
37. INSTALL TIMING CHAIN COVER SUB-ASSEMBLY
38. INSTALL WATER INLET HOUSING
39. INSTALL ENGINE MOUNTING BRACKET FRONT NO.1 LH
NOTICE: Install engine mounting bracket front No.1 LH within 15 minutes after apply FIPG to timing chain cover.
40. INSTALL CYLINDER HEAD COVER SUB-ASSEMBLY LH
41. INSTALL CYLINDER HEAD COVER SUB-ASSEMBLY RH
42. INSTALL OIL PIPE NO.2
43. INSTALL OIL PIPE NO.1
44. INSTALL IGNITION COIL ASSEMBLY
Torque: 10 Nm (102 kgf-cm, 7 ft. lbs.)
45. INSTALL INTAKE AIR SURGE TANK
46. INSTALL OIL PAN SUB-ASSEMBLY
a. Remove any old packing (FIPG) material. Be careful not to drop any oil on the contact surfaces of the cylinder block, rear oil seal retainer and
oil pan.
