toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Emissions - MIL ON/DTC P0456 Set|Page 4546 > < Emissions - MIL ON/DTC P0456 Set
Page 2
background image

Required SSTs

Repair Procedure

1.

Using the Diagnostic Tester, clear the stored DTCs.

2.

Using the Diagnostic Tester, perform the Automatic EVAP System Check to confirm DTC P0456 is pending and the small leak is still present. If
YES, go to step 3.

Refer to the Technical Information System (TIS), 2006 or 2007 model year Avalon Repair Manual, Engine/Hybrid System - Engine Control -
"2GR-FE Engine Control System: SFI System: EVAP System"

NOTE:

If the Automatic EVAP System Check fails to run, perform the following:

^

Turn the ignition key OFF.

^

Turn the Diagnostic Tester OFF.

^

Turn the ignition key ON and the Diagnostic Tester ON, and restart the Automatic EVAP System Check.

If NO codes appear in pending, the problem is intermittent and this TSB does NOT apply.

3.

Disconnect the fuel tank vent hose (between the fuel tank and the canister) from the charcoal canister.

Refer to TIS, 2006 - 2007 model year Avalon Repair Manual, Engine/Hybrid System - Emission Control - "2GR-FE Emission Control: Canister:
Removal"

4.

Using the Diagnostic Tester, clear the stored DTCs.

Emissions - MIL ON/DTC P0456 Set|Page 4546 > < Emissions - MIL ON/DTC P0456 Set