Avalon V6-3.5L (2GR-FE) (2006)
/Page-1339032.png)
HINT: Use the same procedures for the RH side and LH side.
g. Check if the ELR locks.
NOTE: The check should be performed with the outer belt assembly installed.
1. With the belt assembly installed, check that the belt locks when it is pulled out quickly.
If operation is not as specified, replace the belt assembly.
19. INSTALL ROOF SIDE GARNISH ASSEMBLY INNER LH
20. INSTALL ROOF SIDE GARNISH ASSEMBLY INNER RH
21. INSTALL REAR SEATBACK ASSEMBLY RH
22. INSTALL REAR SEATBACK ASSEMBLY LH
23. INSTALL REAR SEAT CUSHION ASSEMBLY
24. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
25. PERFORM INITIALIZATION
NOTE: When disconnecting the negative (-) battery terminal, initialize the following system(s) after the terminal is reconnected.
Initialize Front Power Seat Control System
a. The power seat ECU must be initialized under any of the following conditions.
-
The battery is disconnected.
-
The D/C CUT fuse is replaced.
-
The power seat switch (power seat ECU) is replaced.
-
The power seat assembly is removed from the vehicle.
b. Initialize the power seat ECU as follows.
1. Using the seat switches, fully slide the seat forward, fully recline the seatback forward, and fully raise the seat cushion and headrest.
2. Using the seat switches, fully slide the seat rearward, fully recline the seatback rearward, and fully lower the seat cushion and headrest.
26. INSPECT SRS WARNING LIGHT
Seat Belt Tongue Plate Stopper
NOTE: The content of this article/image reflects the changes identified in TSB BO017-07.
Introduction
A new service part for the seat belt tongue plate stopper has been introduced. Installation procedures are provided to supplement the Repair
Procedures.
Installation Procedure
1. Preparation
A. Shift the tongue plate to the upper portion of the tongue plate stopper, and temporarily hold it with a clip or tape.
B. Remove any pieces of the original tongue plate stopper in the webbing, with a pair of pliers.
CAUTION: Damaged or weakened seat belts may break in an accident and injure the occupant. The seat belt assembly MUST be
replaced if:
-
The webbing is cut, frayed, worn, or damaged.
-
It has been used in a severe impact.
