Avalon V6-3.5L (2GR-FE) (2006)
/Page-1347002.png)
4. REMOVE POWER SEAT SWITCH KNOB
5. REMOVE POWER SEAT SWITCH KNOB
6. REMOVE FRONT SEAT CUSHION SHIELD INNER NO.1 LH
7. REMOVE SEAT SLIDE POSITION SENSOR PROTECTOR
a. Remove the seat slide position sensor protector from the seat position airbag sensor.
8. REMOVE SEAT POSITION AIRBAG SENSOR
a. Disconnect the connector from the seat position airbag sensor.
b. Using a Torx(R) socket wrench (T30), remove the Torx(R) screw and the seat position airbag sensor.
9. INSTALL SEAT POSITION AIRBAG SENSOR
a. Check that the ignition switch is off.
b. Check that the battery negative (-) terminal is disconnected.
CAUTION: After removing the terminal, wait for at least 90 seconds before starting the operation.
c. Using a feeler gauge 1 mm (0.039 in.), install the seat position airbag sensor.
