toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

ABS/TCS - Zero Point Calibration Information|Page 7144 > < ABS/TCS - Zero Point Calibration Information|Page 7142
Page 6
background image

7.

Recheck the position of the "V" mark on the Front Coil Spring Seat Upper in relation to the strut centerline. If the "V" mark is not 0 degrees
CLOCKWISE from the centerline of the strut, repeat step 5 and recheck.

CAUTION:

Inspect the coil spring to verify the painted surface of the spring has NOT been damaged. If necessary, use touch-up paint to cover any areas
where paint has been removed.

8.

Reinstall the both front strut assemblies following the instructions in the Technical Information System (TIS), 2005 or 2006 model year Avalon
Repair Manual, Front Suspension: Front Shock Absorber With Coil Spring.

9.

Check the vehicle alignment and follow the remaining repair procedures per TSB No. ST005-01, "Repair Manual Supplement: Vehicle Pulling to
One Side."

10.

Perform Zero Point calibration after setting the alignment to specification. Refer to TSB No. BR001-04, "Zero Point Calibration, " for Zero Point
reset procedure.

11.

Repeat road test and confirm repair.

Technical Service Bulletin # ST003-06

Date: 060330

Steering/Suspension - Pull/Drift to Right While Driving

STEERING
ST003-06

Title:
VEHICLE SLIGHT PULL/DRIFT FEELING
IMPROVEMENT PROCEDURE

Models:
'05 - '06 Avalon (Touring Edition)

March 30, 2006

Introduction

Some 2005 - 2006 model year Avalon "Touring Edition" customers may complain that the vehicle pulls/drifts slightly to the right while driving. Follow
the repair procedure in this bulletin to correct the condition.

Applicable Vehicles

^

2005 - 2006 model year Avalon "Touring Edition" vehicles produced BEFORE the Production Change Effective VIN shown below.

ABS/TCS - Zero Point Calibration Information|Page 7144 > < ABS/TCS - Zero Point Calibration Information|Page 7142