Avalon V6-35L (2GR-FE) Control Arm Service and Repair Guide
2. REMOVE TRANSVERSE ENGINE MOUNTING INSULATOR
a. Remove the 3 nuts and transverse engine mounting insulator.
3. REMOVE FRONT SUSPENSION ARM SUB-ASSEMBLY LOWER NO.1 LH
a. Remove the 2 bolts on the front side of the front suspension arm sub-assembly lower No.1 LH.
b. Remove the bolt and nut on the rear side of the front suspension arm sub-assembly lower No.1 LH.
c. Remove the front suspension arm sub-assembly lower No.1 LH.
d. Remove the front lower arm bush stopper from the front suspension arm sub-assembly lower No.1 LH.
4. INSTALL FRONT SUSPENSION ARM SUB-ASSEMBLY LOWER NO.1 LH
a. Install the front lower arm bush stopper to the front suspension arm sub-assembly lower No.1 LH.
b. Install the 2 bolts on the front side of the front suspension arm sub-assembly lower No.1 LH.
Torque: 200 Nm (2,040 kgf-cm, 148 ft. lbs.) bolt (A)
c. Install the bolt and nut on the rear side of the front suspension arm sub-assembly lower No.1 LH.
Torque: 206 Nm (2,100 kgf-cm, 152 ft. lbs.) bolt (B)
5. INSTALL TRANSVERSE ENGINE MOUNTING INSULATOR
a. Install the transverse engine mounting insulator with the 3 nuts.
Torque: 87 Nm (887 kgf-cm, 64 ft. lbs.)
6. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE