Avalon V6-3.5L (2GR-FE) (2006)
SST 09930-00010
3. SEPARATE SPEED SENSOR FRONT LH
4. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY LH
a. Remove the 2 bolts and separate the front disc brake caliper assembly LH from the steering knuckle LH.
NOTICE: Use a wire or an equivalent to keep the brake caliper from hanging down by the flexible hose.
5. REMOVE FRONT DISC
6. SEPARATE TIE ROD END SUB-ASSEMBLY LH
SST 09628-62011
7. SEPARATE FRONT SUSPENSION ARM SUB-ASSEMBLY LOWER NO.1 LH
8. REMOVE FRONT AXLE ASSEMBLY LH
a. Put matchmarks on the front drive shaft assembly LH and the front axle hub sub-assembly LH.
b. Using a plastic hammer, separate the front drive shaft assembly LH from the front axle hub sub-assembly LH.
NOTICE: Be careful not to damage the drive shaft boot and speed sensor rotor.
c. Remove the 2 bolts, nuts and steering knuckle LH with the front axle hub sub-assembly LH.
9. REMOVE FRONT WHEEL BEARING DUST DEFLECTOR NO.1 LH
a. Using a screwdriver, remove the front wheel bearing dust deflector No.1 LH.