Avalon V6-3.5L (2GR-FE) (2006)
1. Using a suction cup, position the glass so that the reference marks are aligned. Press it in gently along the rim.
NOTE:
- Allow the primer coating to dry for 3 minutes or more.
- Check that the stoppers are attached to the vehicle body correctly.
- Check that there is a small gap between the vehicle body and glass.
2. Lightly press the front surface of the glass to ensure that the glass is securely fit to the vehicle body.
3. Using a scraper, remove any excess adhesive.
HINT: Make sure that adhesive is applied up to the glass rim.
NOTE: The vehicle should not be driven until the time indicated in the table has elapsed after step (3).
17. INSPECT FOR LEAKS AND REPAIR
a. Conduct a leak test after the adhesive has completely hardened.
b. Seal any leaks with auto glass sealer.