Avalon XL V6-3.0L (1MZ-FE) (1997)
Front Crankshaft Seal: Service and Repair
NOTE: There are 2 methods to replace the oil seal which are as follows:
1. If oil pump is removed from cylinder block.
(a)
Using a screwdriver, pry out the oil seal.
(b) Using Special Service Tool (SST) Cover and Seal Replacer # 09223 - 00010 or equivalent and a hammer, tap in a new oil seal until its
surface is flush with the oil pump body edge.
(c)
Apply Multipurpose (MP) grease to the oil seal lip.
2. If oil pump is installed to the cylinder block.
(a)
Using a knife, cut off the oil seal lip.
(b) Using a screwdriver, pry out the oil seal.
CAUTION: Be careful not to damage the crankshaft. Tape the screwdriver tip.
(c)
Apply MP grease to a new oil seal lip.
(d) Using SST Cover and Seal Replacer or equivalent and a hammer, tap in the oil seal until its surface is flush with the oil pump body edge.