Avalon XL V6-3.0L (1MZ-FE) (1997)
/Page-1763002.png)
3. Disconnect pressure feed tube.
a. Remove the 2 clamp plate set nuts.
b. Remove the bolt.
c. Remove the 2 clamp plates and 2 holders from the tube.
d. Using Special Service Tool (SST) 09631 - 22020, disconnect the tube.
4. Remove drive belt. Loosen the 2 (A and B) bolts.
5. remove PS Vane pump assembly with pressure feed tube.
a. Disconnect the connector from the oil pressure switch.
b. Loosen bolt A sufficiently so that pump assembly can be removed.
NOTE: Bolt A cannot be removed.
6. Remove pressure feed tube.
a. Remove the oil pressure switch from the union bolt.
b. Remove the union bolt and gasket.
INSTALLATION
