Avalon XLS V6-3.0L (1MZ-FE) (1998)
Spark Plug: Testing and Inspection
INSPECTION
INSPECT SPARK PLUGS
NOTICE:
-
Never use a wire brush for cleaning.
-
Never attempt to adjust tile electrode gap on a used spark plug.
-
Spark plugs should be replaced every 100,000 km (60,000 miles).
(a) Remove the ignition coils
(b) Inspect the electrode.
Using a megger (insulation resistance meter), measure the insulation resistance.
Standard correct insulation resistance: 10 M ohms or more
If the resistance is less than specified, proceed to step 4.
HINT: If a megger is not available, the following simple method of inspection provides fairly accurate results.
Simple Method:
-
Quickly race the engine to 4,000 rpm 5 times.
-
Remove the spark plug. (See step (c))
-
Visually check the spark plug.
If the electrode is dry ... OK
If the electrode is wet... Proceed to step (d)
-
Reinstall the spark plug. (See step (g))
(c) Remove the spark plugs.
Using a 16 mm plug wrench, remove the 6 spark plugs from the RH and LH cylinder heads.
(d) Visually inspect the spark plugs.
Check the spark plug for thread damage and insulator damage.