Avalon XLS V6-3.0L (1MZ-FE) (1998)
Wheel Speed Sensor: Service and Repair
Front
REMOVAL
1. Disconnect speed sensor connector.
a. Remove the fender liner.
b. Disconnect the speed sensor connector.
2. Remove speed sensor.
a. Remove the 3 clamp bolts holding the sensor harness to the body and shock absorber.
Torque: 5.4 Nm (48 inch lbs.)
b. Remove the speed sensor from the steering knuckle.
Torque: 8.0 Nm (71 inch lbs.)
INSTALLATION
Installation is in the reverse order of removal.
After installation, check speed sensor signal.