Camry L4-1995cc 2.0L SOHC (2S-E) (1984)
Brake Shoe: Service and Repair
Type 5
Removal
1.
Raise and support rear of vehicle, then remove wheel and tire assembly.
2.
Remove brake drum. If brake drum cannot be remove easily, insert a suitable screwdriver through hole in backing plate, then push adjuster lever
away from adjuster and back of adjustment tension.
Fig. 11 Exploded View Of Type 5 Drum Brake Assembly
3.
Remove tension spring, using a suitable tool, then remove rear shoe hold-down spring and pin. Remove rear brake shoe and anchor spring, Fig.
13.
4.
Remove rear shoe hold-down spring and pin, using suitable tool, then disconnect parking brake cable from lever.
5.
Remove adjusting lever spring and strut from rear shoe.
6.
Position a suitable container to catch fluid, then remove two boots, two pistons, two piston cups and spring from wheel cylinder.
Fig. 3 Measuring Brake Drum Inside Diameter
Inspection
1.
Measure brake drum inside diameter. Inside diameter should be 9.00 inches, Fig. 6.