Camry L4-2.4L (2AZ-FE) (2005)
a. Remove the 2 nuts and BRAKE actuator from the bracket.
4. INSTALL BRAKE ACTUATOR ASSEMBLY
a. Install the BRAKE actuator to the bracket with the 2 nuts.
Torque: 5.4 Nm (55 kgf-cm, 48 inch lbs.)
5. INSTALL BRAKE ACTUATOR WITH BRACKET
a. Install the brake actuator with the 3 nuts.
Torque: 19 Nm (194 kgf-cm, 14 ft. lbs.)
b. Connect the brake actuator connector.
c. Using SST, connect the each brake line to the correct position of brake actuator, as shown in the illustration.
SST 09023-00101
Torque: 15 Nm (155 kgf-cm, 11 ft. lbs.)
6. FILL RESERVOIR WITH BRAKE FLUID
7. BLEED MASTER CYLINDER
SST 09023-00101
8. BLEED BRAKE LINE
9. BLEED BRAKE ACTUATOR ASSEMBLY
SST 09992-00242, 09992-00350
10. CHECK FLUID LEVEL IN RESERVOIR
11. CHECK BRAKE FLUID LEAKAGE
12. CHECK OPERATION OF BRAKE ACTUATOR