Camry L4-2.4L (2AZ-FE) (2005)
Air/Fuel Mixture: Testing and Inspection
INSPECT CO/HC
a) Start the engine.
b) Rev the engine at 2,500 rpm for approximately 180 seconds.
c) Insert CO/HC meter testing probe at least 40 cm (1.3 ft.) into the tailpipe during idling.
d) Immediately check CO/HC concentration at idle and/or 2,500 rpm.
HINT:
^
Complete the measuring within 3 minutes.
^
Check regulations and restrictions in your area when performing 2 mode CO/HC concentration testing (engine check at both idle speed and
at 2,500 rpm).
e) If the CO/HC concentration does not comply with regulations, troubleshoot in the order given.
1) Check A/F sensor and heated oxygen sensor operation.
For additional information see DTC P2A00 in Powertrain Management
2) See the table for possible causes, and then inspect and repair.