Camry L4-2.4L (2AZ-FE) (2005)
2) Install a new gasket and the chain tensioner with the 2 nuts.
Torque: 9.0 Nm (92 kgf-cm, 80 inch lbs.)
NOTICE: When installing the tensioner, set the hook again if the hook releases the plunger.
3) Turn the crankshaft counterclockwise, and disconnect the plunger knock pin from the hook.
4) Turn the crankshaft clockwise, and check that the chain tensioner slipper is pushed by the plunger.
12. INSTALL CYLINDER HEAD COVER SUB-ASSEMBLY
a) Remove any old packing (FIPG) material.
b) Apply seal packing to the 2 locations shown in the illustration.
Seal packing: Part No. 08826-00080 or equivalent
NOTICE:
^
Remove any oil from the contact surface.
^
Install the cylinder head cover within 5 minutes after applying seal packing.