Camry L4-2.4L (2AZ-FE) (2005)
Camshaft Position Sensor: Service and Repair
REPLACEMENT (From July 2003)
HINT: A bolt without torque specification is a standard bolt.
1. REMOVE AIR CLEANER ASSEMBLY
2. REMOVE CAMSHAFT POSITION SENSOR
a. Disconnect the sensor connector.
b. Remove the bolt and sensor.
3. INSTALL CAMSHAFT POSITION SENSOR
a. Apply a light coat of engine oil to the O-ring on the sensor.
b. Install the sensor with the bolt.
Torque: 9.0 N.m (92 kgf.cm, 80 in.lbf)
4. INSTALL AIR CLEANER ASSEMBLY
5. CHECK CONNECTION OF VACUUM HOSE