Camry L4-2.4L (2AZ-FE) (2005)
8. SEPARATE STRUT ROD ASSEMBLY REAR
9. REMOVE REAR SUSPENSION MEMBER SUB-ASSEMBLY
10. REMOVE REAR SUSPENSION ARM ASSEMBLY NO.2 LH
a. Remove the bolt and disconnect the rear suspension arm No. 2 (inner side).
b. Remove the bolt, nut and the rear suspension arm No. 2 (outer side) from rear axle carrier.
HINT: Keep the nut fixed while loosening and removing the bolt.
11. INSTALL REAR SUSPENSION ARM ASSEMBLY NO.2 LH
a. Install the rear suspension arm No. 2 (inner side) with the bolt and temporarily tighten the bolt.
b. Set the suspension arm in the position in the illustration and fully tighten the bolt.
Torque: 100 Nm (1,020 kgf-cm, 74 ft. lbs.)
12. INSTALL REAR SUSPENSION MEMBER SUB-ASSEMBLY
13. TEMPORARY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.1 LH
14. TEMPORARY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.1 RH
HINT: Temporarily tighten the RH side by the procedures with the LH side.
15. TEMPORARY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.2 LH
16. TEMPORARY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.2 RH