Camry L4-2.4L (2AZ-FE) (2005)
/Page-1058002.png)
10. INSTALL SKID CONTROL SENSOR WIRE (W/ ABS)
11. INSPECT BEARING BACKLASH
a. Set a dial indicator near the center of the axle hub and check the backlash in the bearing shaft direction.
Maximum: 0.05 mm (0.0020 inch)
If the backlash exceeds the maximum, replace the axle hub assembly.
12. INSPECT AXLE HUB DEVIATION
a. Using a dial indicator, check the deviation at the surface of the axle hub outside the hub bolt.
Maximum: 0.07 mm (0.0028 inch)
If the backlash exceeds the maximum, replace the axle hub assembly.
13. INSTALL REAR DISC (DISC REAR BRAKE TYPE)
14. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY LH (DISC REAR BRAKE TYPE)
a. Install the rear disc brake caliper assembly LH with the 2 bolts.
Torque: 61.8 Nm (630 kgf-cm, 46 ft. lbs.)
b. Install the rear flexible hose with the bolt.
Torque: 18.8 Nm (192 kgf-cm, 14 ft. lbs.)
15. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY (DRUM REAR BRAKE TYPE)
16. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
17. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
18. CHECK ABS SPEED SENSOR SIGNAL
