Camry L4-2.4L (2AZ-FE) (2005)
Pressure Plate: Specifications
INSTALL CLUTCH COVER ASSEMBLY
a. Align the matchmarks on the clutch cover assembly and flywheel sub-assembly.
b. Following the procedures shown in the illustration, tighten the 6 bolts, in the order starting the bolt locating near the knock pin on the top.
Torque: 19.1 Nm (199 kgf-cm, 14 ft. lbs.)
HINT:
-
Following the order in the illustration, tighten the bolts at a time evenly.
-
Move SST up and down, right and left lightly, after checking that the disc is in the center, tighten the bolts.